11/9/2022 0 Comments Convert file to mm siemens nx![]() ![]() ![]() OK, now assume that the part was converted from mm database units to inches. Say I have designed a sheetmetal part where the material thickness as 2mm and at one point the design required that a 2 inch hole needed to be punched in one of the flanges of the sheetmetal part and the user, using the option to change design units while defining a parameter, either explicitly in the expression system or by changing the input units under Analysis/Units. I have a part file created in NX 4 using metric database units. Granted, unless changed the expression units are consistent with the database units, but that can be changed anytime by the user.Īs an example of what I mean by 'design intent', take the following example as a case in point: The units of an expression is considered to be 'design intent' and therefore NOT related the database units of the part file. The 'ug_convert_part' utility is intended to convert the internal database units, it does NOT change the units assigned to expressions as they have been supported since NX 3. ![]() This issue has been explained on the UGS BBS several times. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |